The MK2  is only available on pre-order (lead time approximately 1 month) - minimum order quantity: 10 pieces.

The MK2 is an Arduino compatible board that is based on the Atmega328P.

It has an onboard RFM69W/RFM69HW transceiver but you can also order it without the transceiver.

You can order the MK2 with a u.FL connector to connect it to an external antenna via a cable, or you can just use the supplied straight wire antenna.

Find out more about the MK2

What you get with this product:

• Canique MK2 board with soldered onboard RFM69 transceiver (if ordered)
• If RFM69 is included: a straight wire antenna of 8.6cm (868MHz) / 17.3cm (433MHz) length. Wire antenna is packaged separately. Not soldered.
• 1x right angle 6 pin Header for the FTDI port, 2x straight 13 pin Headers for the output and input pins. Pin headers are packaged separately. Not soldered.